As the high temperature approached, often in outdoor work of excavator, be sure to check the maintenance of air-conditioning equipment in advance, to avoid failure, when high temperature today excavator accessories factory tutor you how to clean water tank external become warped.
low pressure spray on them using spray on them is the most convenient cleaning tank, sometimes don't even need water gun, a water pipe can solve, almost all construction site can satisfy this condition, convenience is very strong.
Water tank of the heat dissipation fin is very thin, fingers can break off the corner, when flushing must not use too much water, and the need for straight fin, or you might bring down of fin, ultimately affect the heat dissipation.
In addition, from the best tank engine lateral external flushing, because most of the cooling fan is suction type excavator, cold air from the outside to enter at work, will take away the tank heat from escaping through the cabin, so wash from inside to outside fin can more easily clean up the impurities in the fin.
General blocking fin, affect the heat are dust, use water gun flushing to clean out most of the dust, because fin of a smaller gap between internal dust may be unable to clean up, and dust easily under the influence of water and fin stick tighter, so clean with washing method to the effect of the water tank is not the most ideal method.
compressed air flush the second cleaning method is to use a pump to blow wash water tank, because only the equipment repair shop or site management office have air pump, compressed air wash method is slightly worse than the convenience of low pressure spray on them.
Using compressed air flush water tank also should pay attention to adjust the pressure, and also need to purge straight fin, seaborne so fin wouldn't blow down, thus affecting the normal heat dissipation.
Small gap between the fin, the air is better than water through sex, so the forces acting on the internal dust and impurities is larger, easier to fin to clean clean, so the cleaning effect is better than using lower spray irrigation.
detergent for cleaning in the end, you can search by major shopping platform & other
Fin cleaning agent & throughout;
, the purchase price in 20 -
Usage is very simple, use cleaner spray into the air conditioning in the cracks in the fin, then the cleaner will produce a large number of bubbles, and to dust and dirt out of the, rinse again can.
The three kinds of cleaning methods for radiator fin, flushing method is the most convenient, but the effect is not ideal;
Detergent cleaning effect is best, but the cost is slightly high and likely to fin caused some damage.
Using the method of compressed air is good, because the tank does not need often clean, general cleaning one to two times a year, at the time of conditional use air pump to do a thorough cleaning will make excavator & other;
Cool & throughout;
In the summer.
Above is excavator accessories
manufacturers share tank outside fin cleaning methods, hope everybody can get help.
Some information from the Internet, and strive to secure timely, accurate, aims to deliver more information, does not represent the views or responsibility for their authenticity.
If this net reprint information involves the issues such as copyright, please contact with this net.